Arizona Hot Dot 2" pewter AT05 - tarragon

Details:
These tiles are handcrafted from lead free pewter. This limits tarnishing, but some aging can be expected on all finishes. Each tile has a protective coating, special care should be taken to protect its original condition.

Length: 2"

Width: 2"

Thickness: 1/4"

Finish Shown: Satin Pewter

Disclaimer: Due to the handmade nature of the tiles, each tile will show slight inherent variations. These tiles are intended for wall and floor use, in normal household traffic conditions.

Care: Tiles can be treated with an additional clear coat of lacquer if original coat wears. Protect the tiles around dots while applying spray. A pewter polish buffed onto the surface also restores luster. To clean, use a soft cotton cloth or sponge, warm soapsuds or gentle dish detergent. Dry immediately after rinsing to eliminate spotting. When cleaning, be careful not to bring dots in contact with acidic or harsh, abrasive chemicals. Never use steel wool or a scouring pad as this will cause damage. Do not use ammonia based cleaning products.

Installation: 1. Use a professional, knowledgeable and experienced installer.
2. Depending on what type of tile, different types of latex modified thin sets are available. CFlex Pro is suggested for the strongest bond.
3. Allow the adhesive used to apply dots to dry completely before grouting.
4. Cover the dot while installing with low tack painter's tape to keep grout out of the design and prevent scratching.